So, your package has arrived, You open it and are overwhelmed by the amount of parts? Don’t panic. Tutorial: Assembling the Anet A8 3D Printer We recommend you get the Scotch Blue masking tape. Later on, you can also use a glass pen or glass tile. You can get cheap masking tape or painter’s tape from Amazon. You’ll need this for the hotbed, i.e., the area where the prints will be printed. To save yourself from the frustration, get an auto leveling sensor. However, this can get annoying over time. Auto Leveling Sensor (optional): At the beginning, you can adjust your heating bed manually.Get the vernier caliper to help you with the measurements. When it comes to 3D printing, models are measured in millimeters – even fractions of millimeters. Therefore, get about 200m or more of filament in the shopping cart. Small (4 x 4 x 4cm) objects need about 10m of filament, depending on the filling. Filament. The filament is the “ ink” of your 3D printer. Most DIY kits do not come with a filament! You need 1.75mm PLA filament (for learning).Nothing is more annoying than having to wait 10-30 days for new, much-needed parts! Moreover, there is an active community online to help you if you get stuck.īefore you order the printer, read this section carefully. You don’t need any prior knowledge with 3D printers to assemble the Anet 8. Read the comprehensive Anet E10 review here . This new version comes with a power supply in a metal housing, an aluminum frame and a Bowden extruder.

A newer version, the Anet E10 was released in 2017.

The instructions are comprehensive and will allow you to learn how the printer operates, even if you have not used a 3D printer before.ĭespite various revisions, the Anet A8 is still a bit older. We took about four hours to assemble it by following the instruction manual. You have to assemble the parts to build the printer. This means that it arrives in individual parts. The Anet Auto Leveling A8 3D prniter is DIY kit.

In this review, we cover everything: from ordering, through assembly, using the right software, to the first Yoda Buddha figure we printed.īUY ON AMAZON | GEARBEST Technical Specs Model In fact, it is one of the best 3D printers under $300. The Anet A8 3D printer is solidly constructed for the price.

Nicer surfaces? Acetone steam bath for ABS prints.

Anet 8 3D Printer Software: Everything for Gcode, STL and Designs.

Tutorial: Assembling the Anet A8 3D Printer.

Ch341ser mac